HOW TO-Pipe Template
Home Up 110 V Tig Welder Concave Welds Groove Weld Positions For Plate D1 Fitup 1/2" Joint FCAW 71T-1 Settings GMAW Downhill on Square Tubing Work and Lead Angle Dog and Wedge Preset before Welding GMAW Settings Bead Sequence Backstepping Failure of Carbon Steel Pipe Relationship of fillet weld size to strength Tubing Fitup Question Vee Groove With Backing Calibrated Welding Machines Distance Between Welds Undercut/Underfill Opinion On Weld Processes Doubler Pad on Fan Impeller Consumable Insert 6 GR Example Welding Symbol Break Pics and Videos Window Welds Weld Cap Profile Fillet Weld Gauge Qualification Limits By Position Sec IX 7018 Settings HOW TO-Pipe Template Lap Joint Overlap WaterLevel Weld All Around

 

 

Here is a brief example of making a pipe template using parallel line development. The example below is for a mitered elbow on 2-3/8" OD Tubing. 

 

Here is how I do it:

  1. Draw a view of the pipes that shows the angle of intersection.
  2. Draw a circle under the vertical pipe and divide it into 16 equal spaces and number as shown.
  3. Extend vertical lines from the point where the lines drawn in #2 intersect the circle to the angle of cut.
  4. Obtain the circumference of the pipe by multiplying the diameter X 3.1415.
  5. Draw a line to the right of the vertical pipe that is below the lowest point on the angled cut. The length of this line will be that obtained in step 4.
  6. Subdivide the line drawn into 16 equal segments and number the lines 1 to 9 then back down to 1 as shown.
  7. Intersect the numbers as show. (1 to 1, 2 to 2, 3 to 3 etc..)
  8. Draw a line through these intersecting points as shown then cut out the template.
  9. Wrap the pipe and mark and counterpunch.
  10. Cut with a torch keeping the tip pointed towards the imaginary intersection of the two pipe centerlines .

This method works for branch connections with some modifications.  As shown below, for a 90 Deg Branch Connection its just a matter of transferring the lines from the lower circle. If the branch were other than 90 degrees, you would lay it out the same way except from the view that would show the angle of intersection.

 

 

 

 

 

 

 

Hit Counter Since 27 Feb 03